Ampeg BA115HP Combo Rescued from Pawn Shop

This pawn shop find doesn’t work, parts are rattling around inside, and a knob is missing. Watch The Unbrokenstring Crew get this into the practice room!

.

St. Louis Music moved their production to China, which IMHO was the beginning of the end of this fine brand. Que sera sera.

.

I had always wondered if stuff from a pawn shop with obscured serial numbers was a ‘little warm to the touch,’ if you know what I mean. But who would steal something this big?

.

The electronics are out of the cabinet for inspection. A replacement Gain knob is on order from eBay, because someone cranked it up and ripped off the knobs. The ‘Style’ switch, which was broken internally, was put on order as well.

.

This amp sports three band EQ and a Master Volume

.

You can play your CD through the Line Input RCA jacks on the top, and mute the amp to play through headphones. In the muted mode, a built-in chromatic tuner comes on. Neat!

.

The internals of the tuner was one item rattling around inside the unit.

.

The translucent lens over the LED array diffuses the individual LEDs that illuminate when each note is played. This was very dirty for some reason.

.

The tuner electronics and LEDs are one assembly, which makes me think that this was an option for this model.

.

This power cord needs attention. All I need to do is unclamp it, shorten it, and re-clamp.

.

The Chinese did not go cheap on the power transformer. This is the power supply section, with the filter capacitors seen on the left.

.

The power amp is all bipolar transistors. The large white objects are wire-wound resistors. Some of these resistors are open-circuit, but the transistors are all intact. This is interesting…

.

Removing the preamp board, we note that these spacers are required behind the input jacks. The gain control, which needed a knob, is fine.

.

Speaking of spacers, this toothed washer is required behind the Style switch (the white and green item in the center of the picture) to properly set it’s geometry. This is the new switch. The original switch was defective.

.

The ‘sleeve’ contact on this input jack was open-circuit, which caused hum with nothing plugged into the amp. Do you see anything?

.

The contact on the right is not closing when nothing is plugged into the jack.

.

The easiest way to fix this is to just replace the jack, although these can be carefully disassembled and bent back in place. These are inexpensive enough to just replace.

.

The open resistors were identified and removed. Note the round holes in the circuit board.

.

These round holes are for air circulation. I believe that there is a relationship between the plugged holes and the defective resistors.

.

Some of the holes were plugged. The material plugging the holes is adhesive that helps to mechanically support the resistors when the amp is moved. Someone at the factory was sloppy with the hot glue gun!

.

The new replacement resistors are modern high-temperature resistors, spaced above the circuit board for additional heat dissipation. All of the holes in the circuit board are clear now.

.

This part of the circuit board is all cleaned up and ready to reassemble.

.

The raw corners around the mute button can be stained to match the black anodize aluminum. A permanent Sharpie pen works well for this task. A little blending with a finger, before the marker fluid dries, makes the repair invisible.

.

The front view of the finished unit is pretty unremarkable, since the controls are on the top and back. The control in the lower center is a pad for the tweeter. This unit is now 100% and ready to get back to the practice room!

.

Thanks for reading all the way to the bottom!

CONTACT – David Latchaw EE
281-636-8626